Planning a New Sprinkler System in Miami
A good sprinkler system starts with zones: the lawn, the beds, sunny areas and shaded areas each get their own, so each can be watered the right amount. Once the zones make sense, the rest follows: the water source, spray or rotors for turf, drip for beds, a controller with a rain or moisture shutoff, and a layout that keeps water off the house and the street.
This guide is the checklist we walk through with Miami homeowners before anyone digs. It is built on Miami-Dade's landscape code, Florida-Friendly Landscaping standards and UF/IFAS Extension guidance, plus what the ground under Miami is actually like.
Step 1: map the yard
Sketch the property, or mark up a survey or aerial photo. Note:
- Lawn areas, beds, hedges, palms and trees.
- Sun and shade through the day.
- Slopes, low spots and areas that stay wet.
- Driveways, walks, patios, pools and walls that should stay dry.
- Plans for the next few years, such as a pool, an addition or new beds.
Planning for future changes now is far cheaper than cutting into a finished system later.
Step 2: group the yard into zones
A zone is a group of heads or emitters that run together from one valve. Miami-Dade's landscape code asks for systems that allow different schedules by hydrozone, and Florida-Friendly Landscaping standards keep turf and landscape beds on separate zones. In practice:
- Lawn and beds never share a zone.
- Sun and shade should not share a zone when you can avoid it, because shaded areas need less water.
- Spray heads and rotors never share a zone, because they put down water at very different rates.
- Drip never shares a zone with sprays or rotors. UF/IFAS is clear on this one.
More zones cost a little more up front but make every watering day more accurate for years.
Step 3: choose heads and drip
- Lawns: spray heads for small or narrow areas, rotors for larger open turf. UF/IFAS lists rotors at roughly 0.25 to 1 inch per hour and standard sprays at about 0.75 to 2, with high-efficiency rotary nozzles in between. Hunter (manufacturer), for example, rates its MP Rotator nozzles at about 0.4 inch per hour.
- Beds, hedges and planters: drip or micro irrigation, which waters roots, keeps foliage dry and may run at any time under the county rules. The Southwest Florida Water Management District suggests aiming for less than half of the landscape on spray heads and rotors.
- Coverage: Miami-Dade's code calls for low trajectory or low volume devices, even coverage and minimal overspray onto pavement. Heads should reach each other so there are no dry gaps.
Our guide to drip versus spray goes deeper on the choice for each area, and our guide to rotor, spray or drip heads shows which head fits each spot.
Step 4: decide on the water source
- City water through your meter, often with a backflow preventer.
- A private well or a lake, with a pump. That saves on the water bill but adds a pump and its upkeep.
- Reclaimed water, where available, which is exempt from the watering day limits if it is 100% reclaimed.
For the tradeoffs on pumps, rust stains and permits, see well water versus city water. Whatever the source, the Miami-Dade watering rules apply, including for wells and lakes. Read Miami-Dade watering restrictions before you design around a schedule. A design should be able to water every zone well within the allowed hours on two days a week.
Step 5: the controller and the shutoff sensor
Florida law requires every automatic system to have a working device that stops it after enough rain or soil moisture, and Miami-Dade's code requires rain switches or soil moisture sensors where irrigation is provided. Plan for:
- A controller with enough stations for every zone, plus a spare or two.
- A rain sensor, soil moisture sensor or weather based controller. See smart controller vs timer for the trade offs.
- A mounting spot for the rain sensor that is open to the sky and away from spray and trees, as Hunter's installation guide (manufacturer) also advises.
Step 6: plan around Miami ground
Much of Miami-Dade sits on oolitic limestone, often only inches below the surface on the higher ridge areas, with marl soils in lower, wetter areas. USDA NRCS describes the Krome soil, found on the Miami ridge, for example, as 2 to 10 inches deep over limestone bedrock. That affects how trenches are cut, how deep pipe can go and how fast water soaks in. Rocky ground often needs different equipment and more time. Compacted fill on new lots needs shorter watering cycles to avoid runoff, the approach EPA WaterSense calls cycle and soak.
Step 7: protect trees and utilities
- Trees: many cities around Miami regulate work that damages protected trees or their roots, including Coral Gables, Pinecrest, South Miami and the City of Miami, and unincorporated Miami-Dade has its own permit rules. Route trenches around major roots instead of through them.
- Utilities: Florida's underground damage prevention law, Chapter 556, has excavators notify the state one-call system, Sunshine 811, at least two full business days before digging so buried utility lines can be marked. Sunshine 811 tells homeowners planning to dig that they must submit a ticket first.
Step 8: plan the upkeep
Every system needs care to keep working well: seasonal schedule changes, sensor tests, head adjustments as plants grow and a check after storms. Planning for that from day one, whether you do it yourself or use irrigation maintenance, protects the investment.
Questions to ask any installer
- How many zones will there be, and why is each one separate?
- Which areas get spray, rotors and drip?
- What controller and shutoff sensor are included?
- How will the trenches avoid tree roots and utilities?
- How will the system be tested before it is handed over?
- What will the schedule be on my address's watering days?
Get a design for your yard
We design and install complete systems, including drip irrigation for beds, matched heads for lawns, smart controllers and rain sensors. Start with our sprinkler installation service, then request a free estimate and we will walk the property with you.
Sources
Rules and figures in this guide come from the official sources below, plus manufacturer documents where marked. Rules change, so check the source before you rely on a date or a number.
- Miami-Dade County Landscape Ordinance (Chapter 18A)
- UF/IFAS Florida-Friendly Landscaping: Landscape irrigation and design standards
- UF/IFAS AE220: Operation of Residential Irrigation Timers
- UF/IFAS AE524: Microirrigation in the Landscape
- Miami-Dade County: Outdoor water restrictions
- Florida Statutes 373.62: Water conservation; automatic sprinkler systems
- Florida Statutes 556.105: Underground facility damage prevention procedures
- Sunshine 811: 6 steps to safe digging
- Miami-Dade WASD: Water supply and treatment
- Southwest Florida Water Management District: Watering basics for Florida landscapes
- USDA NRCS: Krome soil series description
- U.S. EPA WaterSense: Watering tips
- Hunter: MP Rotator zoning and precipitation rates (manufacturer)
- Hunter: Wired Rain-Clik installation guide (manufacturer)