Well Water vs City Water for Sprinklers in Miami
A private irrigation well usually costs less to run than city water, because you are not paying for each gallon, but it adds a pump to maintain, can stain walls and walks orange with iron, and needs a permit to drill. City water from Miami-Dade Water and Sewer (WASD) needs no pump and leaves no rust, but every gallon shows up on the bill. Either way, the county watering days and hours are the same.
So the choice comes down to four things: what your yard already has, how much you water, whether staining would bother you, and whether reclaimed water reaches your street.
The short comparison
- Running cost: a well uses electricity for the pump instead of metered water. City water has no pump but a water and, in many cases, sewer charge on what you use.
- Equipment: a well needs a pump, a start relay and a suction or drop line. City water feeds the system straight from the meter.
- Staining: well water can carry iron that leaves rust colored marks. Treated city water does not.
- Pressure: a well depends on the pump being healthy. City pressure is steady but shared with the house.
- Permits: a new well needs a well construction permit. Connecting to city water does not need a well permit.
- Watering rules: identical. Two days a week, before 10 a.m. or after 4 p.m.
Watering rules apply to wells too
Many homeowners believe a private well lets them water any day. It does not. Miami-Dade's restrictions cover water from the public utility, private wells, and canals, lakes or ponds. Odd addresses water Wednesday and Saturday, even addresses Thursday and Sunday, and never between 10 a.m. and 4 p.m. The South Florida Water Management District's permit by rule for single family irrigation wells is conditioned on following those same landscape irrigation rules.
The reason is simple: the county's tap water comes from the Biscayne Aquifer, and your well draws from the same shallow limestone. Water you pump onto the lawn is water the region drinks. See our full guide to the watering rules.
Permits for an irrigation well
In the South Florida Water Management District, every new well of any size needs a permit to construct, repair, modify or abandon it, and the work must be done by a licensed water well contractor. In Miami-Dade, the Florida Department of Health in the county handles those well permits on the district's behalf.
For a single family home or duplex, the district grants a general permit by rule for one on site irrigation well, so most homeowners do not need a separate water use permit. One catch: under that rule, if a utility offers reclaimed water at your property line, a private irrigation well is not authorized for lawn watering.
Drilling the well itself is a job for a licensed well contractor. Our work starts at the pump and the sprinkler system it feeds.
Rust stains and what to do about them
Groundwater can carry dissolved iron and manganese. The U.S. EPA lists both among the minerals that cause color and staining problems in water. Sprayed on stucco, pavers or a pool deck, iron oxidizes and leaves orange marks that are hard to remove. Our guide to rust stains from sprinklers covers testing, treatment and cleanup.
Ways to reduce it:
- Aim heads away from hard surfaces. Adjusting arcs so walls, walks and driveways stay dry fixes most visible stains.
- Switch beds near the house to drip. Water at the roots does not hit the stucco.
- Ask about treatment. Some homes add a rust control injection or filter at the well. That is a separate product with its own upkeep.
If the house also drinks from the well, the EPA advises private well owners to test their water regularly, since no utility does it for them. Irrigation only wells are not tested by anyone unless you do it.
The pump is the part that fails
On a well system the pump does the work the city's mains would do. Common problems:
- The pump runs but heads barely rise, which often means lost prime or a leaking check or foot valve.
- The pump never starts, usually a failed pump start relay, a tripped breaker or a wiring fault.
- The pump short cycles or chatters, which wears it out early.
A pump that runs dry can damage itself in minutes, so turn it off if it sounds like it is racing. Our pump repair service diagnoses the pump, relay and suction line and runs every zone before we leave. If spray is weak on every zone, our guide to weak pressure walks through the other causes.
What drives the cost of each
We do not publish prices here because they depend on the property, but these are the factors that move the numbers:
- City water: how many zones you run, how long, and your WASD rate tier. Overwatering usually costs more than anything else, so controller settings matter most on city water.
- Well water: the pump's electricity, its eventual repair or replacement, rust control if you need it, and the cost to drill if you do not already have a well.
- Switching: going from city to well means a permitted well, a pump and repiping at the point of connection. Going from well to city means a connection to the water supply at the meter.
Which should you choose?
- You already have a working well: keep it, keep the pump healthy and aim heads away from stucco.
- You are on city water with a small yard: city water is usually the simpler choice. Put the savings effort into a smart controller and fixing overspray.
- Large lot on city water with high bills: a well may be worth pricing with a licensed well contractor, as long as reclaimed water is not available at your property line.
- Reclaimed water is available: use it. It is exempt from the watering day limits when it is 100% reclaimed.
Planning a new system from scratch? Our guide to planning a sprinkler system covers the water source along with zones and heads.
Get your water source checked
Whether you are on a well or city water, we can run every zone, check the pump or the supply pressure and point out heads that are staining walls or watering the street. Miami-Dade WASD also offers a free landscape irrigation evaluation for homes on its water with a working in ground system. Book a check and tell us which water source your system uses.
Sources
Rules and figures in this guide come from the official sources below, plus manufacturer documents where marked. Rules change, so check the source before you rely on a date or a number.
- Miami-Dade County: Outdoor water restrictions
- Miami-Dade WASD: Water supply and treatment
- U.S. Geological Survey SIM 3541: Biscayne aquifer, Miami-Dade County
- South Florida Water Management District: Well construction permits
- SFWMD: Water well construction permit FAQ
- Florida Administrative Code 40E-2.061: General permit by rule for single family landscape irrigation
- Florida Department of Health: Well construction in Florida
- U.S. EPA: Secondary drinking water standards (iron, manganese and staining)
- U.S. EPA: Private drinking water wells