High Water Bill? How to Find a Hidden Sprinkler Leak in Miami
To find out whether your sprinklers are behind a high water bill, turn off every tap and the irrigation timer, then watch the flow indicator on your water meter. If it moves, close the house shutoff valve. If the meter keeps moving with the house closed off, the water is leaving outside the house, and on most Miami homes that means the irrigation line, a valve that will not close or a broken pipe in the yard. Then run each zone on its own and look for the clues below.
It pays to act quickly. EPA WaterSense estimates that an irrigation leak only 1/32 of an inch across, about the thickness of a dime, can waste around 6,300 gallons a month. Because most systems run before dawn, nobody sees it until the bill arrives.
Step 1: rule out a misread bill
Before you hunt for a leak, make sure there is one. Miami-Dade Water and Sewer (WASD) suggests comparing the numbers on the meter's register with the "Current Reading" printed on your bill:
- Meter lower than the bill: the meter may have been misread. Call WASD Customer Service at 305-665-7477 for a re-read.
- Meter much higher than the bill: water is still being used, and a leak is likely.
The meter usually sits in a box near the street or sidewalk. A screwdriver lifts the lid, and the lens cap flips up to show the dial.
Step 2: the meter test
- Turn off all water inside and outside. Set the irrigation controller to off or rain mode so no zone starts during the test.
- Watch the flow indicator, the small triangle or star on the meter face. If it turns, water is moving somewhere.
- No indicator, or it is not moving? Write down the register, use no water for two hours and read it again. WASD's checklist says a higher second reading means you probably have a leak.
- Close the house valve, usually on an outside wall where the line enters the home or near the water heater, and repeat the test. If the meter still moves, the leak is outside the house.
A meter that only moves when the controller is on, with every zone supposed to be idle, points to a valve that is not closing. A meter that moves with the controller off and the house closed points to a break in the pipe that feeds the valves.
Step 3: run each zone and watch
Start the zones one at a time from the controller and walk each one while it runs:
- A geyser or a gusher at a head: a broken head or riser. These are the easy ones.
- Water bubbling up between heads: a cracked lateral pipe.
- Heads that barely rise on one zone only: water is escaping before it reaches them.
- Water around the base of a head: a worn seal or a cracked fitting.
Spray that gets weaker the farther you go along a zone tells you roughly where the water is leaving. Our guide to weak pressure covers the causes that are not leaks.
Step 4: read the yard between runs
Leaks under Miami's sand and coral rock do not always surface right away. Walk the yard a day after the last watering day and look for:
- Ground that stays soft or muddy when the rest of the lawn has dried.
- A patch that is greener or taller than everything around it, or mushrooms in a dry week.
- Water standing in a valve box, or a valve box that drips after the zone is done.
- Sunken soil or a small sinkhole along a pipe route, where moving water has carried sand away.
- Heads that dribble for a long time after the zone shuts off. Some drainage from the lowest head is normal; a steady trickle all day is not.
EPA WaterSense notes that water pooling between irrigation cycles can be a sign of an underground leak, and that a valve that cannot close completely lets the system seep even when it is off.
Leaks that do not look like leaks
Not every high bill is a broken pipe. Check these before anyone digs:
- A controller that lost its program. After an outage, an old timer can fall back to a default schedule and water far more often. If yours did, here is how to program your sprinkler timer.
- A zone that runs twice. Overlapping programs or a start time entered on two programs can double the water quietly.
- Extra minutes added to fix a dry spot. The dry spot is usually a coverage problem, and the extra minutes run on every head in the zone.
- A valve stuck open. If water runs all the time, read what to do when a zone will not shut off.
WASD's own list of reasons for a high bill includes new sod or plants, filling a pool and house guests, so think about what changed this billing period too.
What WASD can do for you
WASD investigates high bills. The visit checks the meter and the meter box for leaks and looks over the outside of the property, and it is free when your use is unusually high or at least 50 percent above your average quarterly use. You can request it through your miamidade.gov account, by email to wasd_custrelations@miamidade.gov or at 305-665-7477.
WASD also lists a bill adjustment for a high bill caused by a leak that was hidden underground or behind a wall. Keep the repair invoice and photos of the leak, since you will need to show the repair was made. The rules and amounts are set by WASD, so check the account page before you apply.
When to call for help
Find the obvious ones yourself: a snapped head or a geyser takes minutes to spot. Call a pro when the meter says there is a leak and the yard does not show it, when the leak is under a driveway, slab or tree roots, or when a valve keeps weeping after you have cleaned it. The Irrigation Association suggests inspecting your system monthly for leaks and broken heads so small problems do not reach the bill.
Book a leak check
If your bill jumped and the meter keeps moving, we can run every zone, open the valve boxes and trace the line until we find where the water is going. Our leak repair service fixes the break and runs the zone again to prove it holds. Book a check and tell us how much your bill went up. The dates help us narrow it down. Found the break already? Our guide to a broken sprinkler pipe covers what to do next, and our sprinkler repair in Miami page lists every repair we handle.
Sources
Rules and figures in this guide come from the official sources below, plus manufacturer documents where marked. Rules change, so check the source before you rely on a date or a number.
- U.S. EPA WaterSense: Fix a Leak Week
- Miami-Dade WASD: Leak detection tips
- Miami-Dade WASD: Leak detection checklist
- Miami-Dade WASD: Your water and sewer account (high bill investigation and bill adjustments)
- U.S. EPA WaterSense: Sprinkler spruce up
- U.S. EPA WaterSense: Find it, flag it, fix it landscape checklist
- Irrigation Association: The homeowner's guide to landscape irrigation
- Rain Bird: Troubleshooting and maintenance guide for residential valves (manufacturer)