(786) 496-4049 Contact Us

What a Sprinkler Wet Check Includes, Zone by Zone

By the Irrigate Miami team · Published October 19, 2026 · 5 minute read

Pop up spray head watering green turf up close

A wet check means running every zone of the sprinkler system, one at a time, while someone walks it and watches each head, the valve and the rain sensor. It is the only reliable way to find broken or blocked heads, leaks, overspray onto pavement and dry spots before the lawn and plants show the damage.

Most problems in a Miami system are invisible when it runs at 5 a.m. on your watering day. A wet check brings them into daylight. Here is what a thorough one covers, what you can do yourself and what the results should tell you.

Why it matters in Miami

Systems here run all year, and they run hard. Sand and grit wear out nozzles and valve seats, St. Augustine slowly buries heads, mowers and cars break them, and roots crack lines. UF/IFAS Extension lists routine checks as the core of irrigation maintenance: unclogging or replacing broken heads, keeping heads upright and above the turf, and adjusting them off paved areas. EPA WaterSense's Sprinkler Spruce Up checklist covers the same ground and adds leaks, pooling water and valves that do not close fully.

The county rules also make every watering day count. With two days a week, a zone that misses a corner leaves that corner dry for days.

The four things it should answer

A useful wet check answers four questions, and the rest of this guide follows them:

  • Hardware: are the heads, valves, controller and sensor working?
  • Coverage: does every zone reach its whole area evenly, without hitting pavement?
  • Schedule: do the days, start times and run times fit the season and the rules?
  • Plant response: do the lawn and beds look like they are getting the right amount?

Before the water goes on

A good wet check starts at the controller and the water supply:

  • Controller: date, time, active programs, start times, run times per zone and the watering days. They should match your address under the watering rules.
  • Rain sensor: connected, not in bypass, and mounted in the open, out of the sprinkler spray, as Hunter's installation guide (manufacturer) advises. Florida Statutes 373.62 requires a licensed contractor to test the shutoff device before doing other work, and to repair or replace it if it fails.
  • Supply: the irrigation shutoff and backflow valves fully open, and on well or lake systems, the pump starting cleanly. Rain Bird's valve guide (manufacturer) starts troubleshooting with the same basics: the controller programmed, the main shutoff and flow control open, and the pump working.

Zone by zone

Each zone runs on its own while the technician walks it. For every zone, the check covers:

  1. Every head pops up and seats back down. Heads that stick up get mowed; heads that stay down water the grass blades.
  2. Spray pattern and distance. Broken fans, misting, short throw or a head spraying the house, the fence or the street.
  3. Coverage. Each head's water should reach the next head, so there are no dry gaps between them. EPA WaterSense calls this head to head coverage.
  4. Height and angle. UF/IFAS recommends heads at right angles to the soil and raised above the turf, often a couple of times a year as grass grows.
  5. Leaks. Bubbling around a head, a geyser, a soggy patch or water seeping from a valve box. The Southwest Florida Water Management District notes that water pooling around the base of a head points to a loose seal.
  6. The valve. The zone opens and closes cleanly and stops fully when the run ends.
  7. Matched heads. Sprays and rotors are not mixed in one zone, and nozzles match, so the zone waters evenly. Hunter (manufacturer) advises zoning nozzles with different precipitation rates separately.

Drip zones get a walk too: emitters in place, no blowouts, a clean filter and plants getting water at the roots.

Measuring what each zone applies

A wet check can also measure output. UF/IFAS describes a simple can test, and EPA WaterSense suggests a similar one with tuna cans: set several straight-sided cans in a zone, run it for 15 minutes, average the depth and multiply by four for inches per hour. With that number, run times can be set to deliver the 1/2 to 3/4 inch per watering UF/IFAS recommends for lawns, instead of guessing.

What a wet check usually finds

The same handful of problems show up again and again in Miami yards:

  • Heads buried by St. Augustine runners or tilted by roots.
  • Nozzles clogged with sand, or swapped for the wrong type over the years.
  • Heads aimed at driveways, walls and windows.
  • Valve diaphragms that weep, so the lowest head drips between waterings.
  • Rain sensors that were bypassed or mounted under a tree.
  • Controllers still running a summer schedule in January.

After the check

The result should be a clear list of what was adjusted on the spot and what still needs repair, with the reason for each. A good technician shows you what failed rather than just handing you a total. Small fixes like aiming heads, cleaning screens and resetting the controller are usually part of the visit; broken heads and leaks become repairs such as sprinkler head replacement.

Can I do my own wet check?

Yes, and it is worth doing between professional visits. Use the controller's manual run, start one zone at a time and walk it. The county allows repair and maintenance runs outside your watering days once a week, up to 10 minutes per zone, with someone on site. Watch for the problems in the list above, flag anything odd with a stick or a flag, and fix what you safely can.

What a homeowner check usually misses is the inside of the system: valve condition, sensor wiring, controller settings and real output. That is where a professional visit earns its keep.

How often?

At least once a year, and ideally when the seasons turn: as the rains start in late spring and as they end in the fall, plus after any big storm. Our seasonal sprinkler schedule explains the timing, and our older monthly irrigation maintenance checklist covers the small jobs in between. If you would rather not track it, maintenance plans include regular checks and seasonal controller adjustments.

Book one

A tune-up is our full wet check: every zone, the controller, the rain sensor tested in front of you and a plain list of what we found. Book a visit and we will start at the controller.

Sources

Rules and figures in this guide come from the official sources below, plus manufacturer documents where marked. Rules change, so check the source before you rely on a date or a number.

Written by the Irrigate Miami team

Local irrigation technicians with over 20 years of experience repairing, installing and maintaining sprinkler systems across Miami-Dade.

Get your free estimate

Tell us what is going on with your system and we will get back to you with next steps and a clear price.

CallGet a Free Estimate